Error message

Notice: Trying to get property 'total_page_loads' of non-object in eval() (line 16 of /Sites/Drupal.Fossee.All.Sites/modules/php/php.module(80) : eval()'d code).

Resources

Here you can find information on the Arduino shield, various components required for performing experiments given in the book.

The vendor information is also provided from where you can purchase shields and components.

About the Floss-Arduino Shield:

The Shield is a printed circuit board (PCB) designed by the FOSSEE team at IIT Bombay. The Shield has numerous components like LED, sensors, actuators, Potentiometer, etc, all wired to the respective pins of the Arduino. Hence, it is a ready-to-use kit and users don't have to worry about connections of various sensors. It obviates the need for a breadboard as an intermediate tool for electronics circuit prototyping, which is quite cumbersome for beginners. The shield provides the user a faster way of circuit prototyping without troubleshooting.

FLOSS-Arduino Shield - Download

Arduino shield with pinouts.

Refer to the table below for the list of components and their values used in this book.

Components	Description / Values	Quantity
R1 R10	100R	2
R2 R3	91R	2
R6 R7 R8	10K	3
R9	1K	1
D1	Diode	1
Relay	Relay	1
X1	Terminal Block	1
Piezo	Buzzer	1
SERVO	Servo motor	1
POT	Potentiometer	1
HALL	Hall Sensor	1
THERM	Temperature sensor	1
PHOTO	Light Dependent Resistor	1
BUTTON	Push Button	1
RGB	RGB LED	1
T1	Transistor	1
Header	6-pin header	2
Header	8-pin header	2
Motor Driver	L293D motor driver board	1
Motor	Toy motor	1